Staufenbiel EDGE 540 Anleitung Seite 35

INSTALL THE PROPELLER
Caution: Disconnect the battery from the ESC be-
fore installing the propeller. Before testing the pro-
peller, make sure the tail of the plane is firmly on the
ground and ensure there are no people or objects
in the range of the propeller. Make sure the throttle
stick and the trim on the lowest position before plug
in the battery.
1. The propeller and spinner set.
2. Place the self-locking nuts rightly into the outboard
hex notch on the bottom of the spinner back plate.
Don't install the inboard hex notch self-locking nuts.
Note: Always use a piece of scrapped board (lami-
nated board, plastic or metal board) hold the nuts
into place in the process of blades mounting.
3. Fit the blade in place with the letter side face up,
use the shorter screw (18mm) to secure the blade tip
side screw hole. Make sure holding the nut into place
when tighten the screws to save time.
Note: Only secure the inboard propeller hole as
picture shows.
EN
35