Assembly Instructions; Attaching And Removing The Blower/Vacuum Tube; Attaching And Removing The Vacuum Bag - Mogatec GLBI 750 Gebrauchsanweisung

ASSEMBLY INSTRUCTIONS

ATTACHING AND REMOVING THE BLOWER/VAC-
UUM TUBE
NOTE: The blower/vacuum tube comes unassembled
on this unit. Installation required to provide safe and
easy use for the operato.
Assembling the two tube elements :
1. Fit the upper and lower vacuum/blower tubes to-
gether by sliding them into each other as far as it
will go. Thereby pressure the two bolting device
buttons.
2. Install the two self-tapping screws on both sides
(Fig. 1).
Attaching the Blower/Vacuum tube
1. Remove the screws and nuts provided from the
hardware pack.
2. Insert the blower/vacuum tube all the way into the
opening on the motor housing until the holes in
the tabs on the blower/Vacuum tube align with the
screw holes in the housing (Fig. 1).
3. Insert the 2 (two) T20 Torx screws (A) into the right
side of the motor housing and the 2 (two) pertaining
nuts into the left side of the motor housing (Fig. 2).
4. Tighten the screws firmly. Do not over-tighten.
5. Install the 2 (two) remaining self-tapping T20 Torx
Screws (B) into the holes on either side of the hous-
ing (Fig. 2). Tighten until snug, do not over-tighten.
Attention:
Before using the unit, make sure the vacuum tube
is correctly seated and fixed with screws.
Removing the Blower/Vacuum Tube
WARNING: To avoid serious injury switch off
the engine and wait until the impeller fully stops
before attaching or removing tube parts.
1. Remove the two self-tapping screws from either
side of the housing (Fig. 2).
2. Remove the two screws and nuts holding the blow-
er/vacuum tube to the housing (Fig. 2, Fig. 3).

ATTACHING AND REMOVING THE VACUUM BAG

Attaching the vacuum bag
1. Attach the vacuum bag to the vacuum bag hook on
the blower/vacuum tube (Fig. 4).
2. Slide the vacuum bag tube over the debris exhaust
tube on the housing as far as it will go (Fig. 5).
3. Use two self-tapping screws on each side to secure
the vacuum bag to the debris exhaust tube on the
blower housing (Fig. 5).
4. As a rule, the vacuum bag will not be removed after
it has been attached any more – except for mainte-
nance purposes.
GB-7