Axis T91A61 Installationsanleitung Seite 11

AXIS T91A Series Installation Guide
Install the AXIS T91A64 Corner Mount
Hardware overview,
1. Refer to
parts.
2. Attach the corner bracket in the desired position using screws that are
appropriate for the wall material and the weight of the camera and
bracket.
3. Attach the bracket holder (not included) to the corner bracket using the
supplied screws.
4. The wall bracket (not included) can temporarily be hooked on the bracket holder, in order to
easily route the cable through the bracket:
Bracket
holder
Slide bracket between the
tabs on the bracket holder
Note:
The bracket holder and wall bracket (AXIS T91A61) are required for the installation but
must be purchased separately, see the table in
5. Route the necessary cables through the wall bracket, securing them in the cable holder.
6. Press the locking tab and unhook the wall bracket from the temporary position.
7. Use the Torx screws to secure the wall bracket to the bracket holder.
8. Refer to the Installation Guide for the network camera for instructions on how to attach the
camera to the bracket.
on page 4 for information on the supplied
Tabs
Wall bracket
Corner bracket
Package contents,
Cable Cable
holder
Swing wall bracket
to the side for
temporary support
on page 3.
Page 11
Locking tab