Function Description - Grizzly ERT 46 Pro Bedienungsanleitung

• Pay attention to the line cutter. It can
cause serious laceration injuries.
• Never attempt to stop the cutting equip-
ment (cutting line) with the hand. Always
wait until it stops by itself.
After switching off the device, the
cutter head still rotates for some
seconds.
• Employ only an original cutting line or
original blade. The utilization of a metal
wire instead of the plastic line is forbid-
den.
• Do not use the device in order to cut
grass that is not on the ground e.g. grass
that grows on walls, rock etc.
• Do not cross any gravel-strewn roadways
or paths with device still running.
• Do not use the device near flammable
liquids or gases. In case of non-observ-
ance, fire or danger of explosion exists.
• Within the range of action, the user is re-
sponsible for damages to third parties
which have been caused by the use of
the device.
• Ensure the vent holes have not been
clogged up.
• Remove the power plug in case of non-
use, while cleaning the device, before
maintenance or the replacement of ac-
cessories. Ensure the device is switched
off when you insert the plug into the plug
socket.
• Store the device in a dry location and out
of the reach of children.
• Use only those replacement and acces-
sory parts which are supplied and recom-
mended by the manufacturer.
• Do not attempt to repair the device your-
self. All work, which is not indicated in
these directions, may be carried out only
by service stations authorized by us.
Protection against electric shock:
Keep extension cables away from
cutting equipment. If the extension
cable is damaged during use, un-
plug it immediately from the mains
power supply. DO NOT TOUCH THE
CABLE UNTIL YOU HAVE UN-
PLUGGED IT FROM THE MAINS.
• Ensure that the mains voltage agrees
with the information of the label.
• As far as possible, attach the device only
to a plug socket with leakage-current-op-
erated circuit breaker (FI switch) with a
rated current of not more than 30 mA.
• Protect the device against humidity. The
device must not be moist and neither
should it be operated in a moist environ-
ment.
• Before every use, check the device and
the power cable with plug for damages.
Avoid body contact with grounded parts
(e.g. metal fences, metal posts).
• Employ only extension cords which are,
at most, 75 m long and which have been
stipulated for use in the open air. The
flexible lead cross-section of the exten-
sion cord must be at least 1.0 mm
ways roll a cable drum out completely be-
fore use. Check the cable for damage.
• Never cross over the extension cord with
turned on device. Basically, play the
mains cable out behind the operator.
• Employ the cable attachment device pro-
vided for the fixing of the extension cord.

Function description

The hand-guided and portable lawn trimmer
has an electrical motor as a drive. As cutting
equipment the lawn trimmer uses a double-
line spool. During the cutting procedure, two
plastic lines rotate around an axis vertical to
the cutting plane.
GB
2
. Al-
29 29