Barometer; 12-Hour Air Pressure History; Outdoor Sensor/Channel Setting - Auriol IAN 307252 Bedienungs- Und Sicherheitshinweise

Sunny
Slightly
cloudy
Cloudy

Barometer

Your weather station can show the air pressure tendency 4.
Air pressure rising
Air pressure constant
Air pressure falling
You can also select absolute or relative air pressure by pressing the
Relative/Absolute-button 25. Rel. or Abs. will appear on the display.
Note: The weather station measures the absolute air pressure. Your local
weather service can supply you with the relative air pressure for your location,
which you can input into the weather station.
To change the relative air pressure, press and hold the Relative/Absolute-button
25 for 3 seconds. The air pressure value will blink on the display and can be set
by pressing the °C/°F + -button 29 or MAX/MIN-button 27. Confirm your setting
by pressing the Relative/Absolute-button 25.
Select the air pressure unit Hectopascal (hPa) or Inches of mercury (inHg) by
pressing and holding the °C/°F + -button 29 for 3 seconds.

12-hour air pressure history

Press the HISTORY/WEATHER-button 31 to view the air pressure history for the
last 12 hours.
0 – HR = current air pressure
- 1 HR = air pressure 1 hour ago
-2 HR = air pressure 2 hours ago... and so on

Outdoor sensor/channel setting

You can use the weather station with up to 3 outdoor sensors at the same time.
Open the battery compartment of the outdoor sensor 43 and select a channel (1-
3) by using the Channel selection switch 42. Press and hold the CHANNEL-button
33 for 3 seconds or until an audible signal sounds. The weather station will now
attempt to receive the signal 3.
Now press the TX-button 40 to manually transmit the temperature from the outdoor
sensor to the weather station.
Close the battery compartment. Press the °C/°F-button 39 to select °C-Celsius or
°F-Fahrenheit.
Note: The outdoor sensor must be within a maximum distance of 100 m of the
weather station with no obstructions.
If you are using mutliple outdoor sensors: Press the CHANNEL-button 33 to select
the reception channel.
The rotation symbol on the display at 23 indicates that the weather station is
rotating through channels 1-3.
Only active outdoor sensors are displayed. Press and hold the CHANNEL-button
33 to remove unused channels. When adding an additional outdoor sensor, the
weather station will detect it automatically. You can also manually transmit the
signal by pressing the TX-button 40.
Downpour
Rain
Heavy
snowfall
Snow
- 9 -