ION Block Party Ultra Schnellstartanleitung Seite 8

Light Modes
Select from one of the light modes for the dome and woofer lights using the remote control.
Individual color buttons can be de-selected to have only the colors you want displayed without
interrupting the mode.
Dome Lights
When the Top Light button is pressed, the colors will turn on and slowly cycle through
different color combinations. Press the Top Light button again to have the colors quickly cycle
through different color combinations. When music begins to play, the lights will react to the
beat of the music, cycling to the different color combinations. At any time, a color can be
selected to toggle that color on or off. Pressing All Off will turn all colors off. Then, select
which colors you wish to illuminate. Press the Fade button to create fading effects, slowly
cycling from one color to the next. Press the Flash button to create flash effects. If the Top
Light button is pressed again, the lights will turn off. When the Still button is pressed, all 6
colors are on, and the lights are static (no motion). At any time, a color can be selected to
toggle that color on or off. Pressing All Off will turn all colors off. Then, select which colors you
wish to illuminate.
Woofer (Cone) Lights
When the Speaker Light button is first pressed, the colors will slowly fade from one color to
the next. If the Speaker Light button is pressed again, the lights will quickly change color along
with the beat of the music. If the Speaker Light button is pressed again, the lights will turn off.
Pairing a Bluetooth Device
1. Turn on your Bluetooth device.
2. Power on Block Party Ultra.
3. Navigate to your Bluetooth device's setup screen, find Block Party Ultra and connect.
Note: If your Bluetooth device prompts for a pairing code, enter "0000".
4. To disconnect pairing while the Bluetooth icon is lit solid, press the Bluetooth button.
5. To connect to another Bluetooth device, repeat step 3.
Connecting Two Speakers
To link two Block Party Ultra speakers:
1. Plug a 1/8" (3.5 mm) cable into the Speaker Link output located on the rear panel of one
Block Party Ultra.
2. Plug the other end of the 1/8" (3.5 mm) cable into the 1/8" Aux input of another Block
Party Ultra.
3. Power on both speakers. Use the Mic Volume on the second speaker to adjust the input
signal level.
8