Led Indicators; Technical Support - D-Link DGS-1005D Installations Anleitung

A. Power:
Power is supplied through an external DC power adapter. Check the technical
specification section for information about the DC power input voltage. Since the DGS-
1005D / DGS-1008D does not include a power button, plugging its power adapter into a
power outlet will immediately power it on.
B. Gigabit Ethernet Ports
These ports support network speeds of 10Mbps, 100Mbps or 1000Mbps, and can
operate in half- and full- duplex transfer modes. These ports also support automatic
MDI/MDIX crossover detection, which gives the Switch true, "plug and play"
capabilities. Just connect any network cable between the Switch and the device,
and The Switch will automatically detect the settings of the device and adjust itself
accordingly.

LED Indicators

DGS-1005D
The LED Indicators will allow you to monitor, diagnose and troubleshoot any potential
problem with the switch, connection or attached devices.
A. System Power:
The LED indicator lights green when the Switch is receiving power, otherwise, it is off.
B. Link / Act:
These LED indicators are lighted up when there is a secure connection (or link) to any
ports. The LED indicators blink whenever there is reception or transmission (i.e. Activity-
Act) of data occurring at a port.
C. Speed 1000/100/10Mbps
The LED indicator lights green when the port is connected to a 1000Mbps Ethernet
station, and amber when connected to a 100M Fast Ethernet device. The indicator
remains off when the port is connected to a 10Mbps Ethernet device.
D.Cable Diagnostic - LED Indications
The Cable Diagnostic first scans the 5 / 8 Ethernet ports to determine if the Ethernet
cable is in good working order. This process is indicated by the Speed LED blinking
green for each of the 5 / 8 ports sequentially. The initial port scan takes about 10
seconds. If a cable fault is detected, it is indicated by the corresponding port's Speed
LED glowing amber for 5 seconds after the initial port scan. If the cable connection is
good, the corresponding port's Speed LED will glowing green for 5 seconds. After the
display of cable status, the Switch is then reset for normal operation.

Technical Support

Thank you for choosing D-Link products. For further information, support, product drivers
and manuals please visit the D-Link website at www.dlink.eu.
www.dlink.co.uk
UK: 08456 12 0003

DGS-1008D