Parameter Adjustment - Quick Setup; Parameter Adjustment - Extended Adjustment - Balluff BMD 1L serie Betriebsanleitung

6 Set up with the display and adjustment module
Switch-on phase
Measured value indica-
tion
Quick setup
28
After switching on, the BMD 1L carries out a short self-test where the
device software is checked.
The output signal transmits a fault signal during the switch-on phase.
The following information is displayed on the display and adjustment
module during the startup procedure:
•
Instrument type
•
Device name
•
Software version (SW-Ver)
•
Hardware version (HW-Ver)
With the [->]
modes.
digits.
In the second view, the selected measured value and a correspond-
ing bar graph presentation are displayed.
In the third view, the selected measured value as well as a second
selectable value, e.g. the temperature, are displayed.
6.3

Parameter adjustment - Quick setup

To quickly and easily adapt the sensor to the application, select
the menu item "Quick setup" in the start graphic on the display and
adjustment module.
The following steps for the quick setup can be reached also in the
"Extended adjustment".
•
Instrument address
•
Measurement loop name
•
Medium type (optional)
•
Application
•
Max. adjustment
•
Min. adjustment
•
False signal suppression
ing chapter "Parameter adjustment - Extended adjustment".
6.4

Parameter adjustment - Extended adjustment

For technically demanding measuring points, you can carry out
extended settings in "Extended adjustment".
-