Getting Started; Unpacking; Connecting The Heartsim 200; Connecting The Als Baby Trainer - laerdal Heartsim 200 Gebrauchsanweisung

HS 200 DfU 02-15EN.qxd 12.11.03 13:25 Page 5
3 . G e t t i n g S t a r t e d

3.1 Unpacking

Remove the Heartsim 200 from its packaging.
If there is any obvious sign of damage, immediately notify
Laerdal Medical and the carrier. Remove the battery cover
and then remove the battery tag that is temporarily installed
to prevent discharge of the batteries.

3.2 Connecting the Heartsim 200

3.2.1 Connecting the Manikin
To connect the ALS Skilltrainer to the Heartsim 200, connect the
cable from the side of the manikin to the connector on the top end
of the Heartsim 200. This port also accepts the Heartsim 200 link
cable plug.
Note: The plug will only enter the receptacle
with the correct orientation.

3.2.2 Connecting the ALS Baby Trainer

Connect the manikin's three connectors onto the ECG mounts on
the top of the control panel. These mounts can also connect directly
to an ECG monitor for rhythm recognition training.
5