KERN ALT 160-4NM Betriebsanleitung Seite 142

Press key; the display changes into parts counting
operation
The balance is now in parts counting mode counting all
units on the weighing plate
01 Reference weight – determination of reference weight through weighing
Press key; display changes to counting mode
Press the key; use arrow keys to select reference
quantity (factory-defined are quantities of
or freely selectable),
Place as many counting parts on the balance as the set
reference quantity requires, confirm by pressing the
key. If you are using a weighing container first tare your
balance pressing the
Press button
The symbol (
reference optimization is switched on. Every time more
pieces are added the balance carries out optimization
automatically. It is not necessary to press another key to
start the optimization process. For each reference opti-
mization the average piece weight (reference) is newly
calculated. As the additional pieces increase the base
for the calculation, the reference also becomes more ex-
act.
Operate the
under "01 Unit weight".
Press the key; the balance is now in parts counting
mode counting all units on the weighing plate.
ALT/PLT-BA-e-0721
use the key to confirm
key.
) in the display indicates that automatic
key. The reference quantity is saved
10, 20, 50,100,
Parts counting setup
M1 01 Unit weight 5.0000
02 Recall sample
03 Store sample
04 Checkweighting
OFF
05 Filling
OFF
06 Statistics
OFF
07 Run
59
g