Wilo Control DigiCon-A Einbau- Und Betriebsanleitung Seite 30

English
5.2 Technical data
Supply voltage
Current consumption
Terminal cross-section of all terminals
Max. ambient temperature
Protection class according to IEC 60529
Rel. humidity
Electromagnetic compatibility:
• Emitted interference
• Immunity to interference
Contact charge, signal contacts
• Collective fault signal
potential-free changeover contact
• Single operation signal MA
potential-free normally open contact
• Single operation signal SL
potential-free normally open contact
Contact charge through control inputs
• "Ext. Off"
potential-free normally open contact
• "Control On"
potential-free normally open contact
• "Max. Speed"
potential-free normally open contact
• "Min. Speed"
potential-free normally open contact
Max. cable length per control input
Loop resistance per control input
Control input "Analogue In 0...10 V"
• Input resistance
• Overvoltage protection
PLR interface
• Max. cable length
• Min. cable cross-section
Tab. 3
24
DigiCon
24 VDC ± 25%
70 mA (without DigiCon-A)
140 mA (with 1x DigiCon-A)
210 mA (with 2x DigiCon-A)
1.5 mm
+ 50°C
IP 20
Max. 95%, not condensing
EN61000-6-3
EN61000-6-2
250 VAC, 1 A AC-1/
110 VDC, 0,13 A DC-1
200 m
2
2x0.5 mm
DigiCon-A
Power supply by
DigiCon
2
Max.:
Min.:
12 VDC, 10 mA
24 VDC, 2.4 mA
24 VDC, 2.4 mA
24 VDC, 2.4 mA
24 VDC, 2.4 mA
1000 m
Max. 480 Ω
> 200 kΩ
+/- 48 VDC
WILO SE 04/2009