Intended Use; Features; Scope Of Delivery; Technical Data - Parkside PMBS 105 A1 Bedienungs- Und Sicherheitshinweise Und Originalbetriebsanleitung

Introduction
Modelling belt sander PMBS 105 A1
Introduction
Q
We congratulate you on the purchase of your new
device. You have chosen a high quality product.
The instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as descri-
bed and for the specified applications. If you pass
the product on to anyone else, please ensure that
you also pass on all the documentation with it.

Intended use

The belt sander is designed for model making, tool-
ing and shaping. However, it is also suitable for small
car repairs, e.g. bodywork. The tool can also be
used for deburring, rough machining, finish grinding,
edge breaking, paint removal, rust removal and
sharpening tools, as well as working on metal, non-
ferrous metals, wood and plastic. The device is not
intended for commercial use. Any other uses, and /
or modifications to the tool are considered improper
use and may result in serious hazards. The manufac-
turer is not liable for damage caused by improper use.

Features

ON / OFF switch
1
Connection cable with mains plug
2
Connection socket
3
Slide for tensioner
4
Tensioner
5
Adjusting knob
6
Extraction adapter
7
Dust extractor hose
8
Screw clamp
9
Belt support
10
Abrasive belt
11
Drive roller
12
Notch
13
36 GB

Scope of delivery

1 Modelling belt sander PMBS 105 A1
1 Abrasive belt (installed)
1 Extraction adapter (for external dust collection)
1 Dust extractor hose
1 Screw clamp
1 Set of instructions for use

Technical Data

Modelling belt sander PMBS 105 A1
Rated voltage: 230 V∼ 50 Hz
Operating mode:
Short term use: S2 10 min
Note: After a continuous operating time of 10
minutes, a rest period is enabled, until the device has
cooled to a temperature within 2 K (2 °C) of the
room temperature.
Rated power input: 105 W
Idle belt -
speed: 170 m / min
Idle speed: n
0
Abrasive belt: 40 x 265 mm
Grinding surface: 60 x 40 mm
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 81.20 dB(A)
Sound power level:
Uncertainty K:
Vibration- and noise reduction
To minimise the impact of vibration and noise, limit
the work time, use the settings for lower vibration-
and noise emission, and wear personal protective
equipment.
Please observe the following points to minimise the
vibration- and noise emission:
1. Only use the product properly in accordance
with the design and the instructions.
2. Ensure the product is in good working order and
well maintained.
640 min
-1
92.20 dB(A)
3 dB