Fitting The Trimmer Guard And Trimmer Head; Fitting The Transport Guard - Husqvarna 143RII Bedienungsanweisung

• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support
flange (F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm. Use the spanner in the tool kit. Hold the
shaft of the spanner as close to the blade guard as
possible. To tighten the nut, turn the spanner in the
opposite direction to the direction of rotation (Caution!
left-hand thread).
Fitting the trimmer guard and trimmer
head
• Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard
extension is fitted.
L
M
A
• Hook the trimmer guard/combination guard onto the
fitting on the shaft and secure with the bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
16 – English
ASSEMBLY
G
E
F
D
B
C
H
B
C
M L
• Screw on the trimmer head/plastic blades (H) counter
clockwise.
H
• To dismantle, follow the instructions in the reverse
order.

Fitting the transport guard

• Insert the blade in the transport guard (A).
• Snap the two fasteners (B) into the slots (C) to secure
the transport guard.
2-teeth blade
• Insert the blade in the transport guard.
A
H