Reading (X) And Resetting (Z) Of Sales Totals - Sharp XE-A303 Bedienungsanleitung

READING (X) AND RESETTING (Z)
OF SALES TOTALS
• Use the reading function (X) when you need to take a reading of sales information entered since the last reset.
You can take this reading any number of times. It does not affect the register's memory.
• Use the resetting function (Z) when you need to clear the register's memory. Resetting prints all sales information and
clears the entire memory except for the GT1 through GT3, Training GT, reset count, and consecutive number.
Summary of Reading (X) and Resetting (Z) Reports
1
X1 and Z1 reports: Daily sales reports
X2 and Z2 reports: Periodic (monthly) consolidation reports
When you take an X or Z report, turn the mode switch to the appropriate position referring to the column of
"Mode switch position" shown on the table below, and use the following corresponding key sequence.
Item
Flash report:
(Only display)
To clear the
display, press the
l
key or turn the
mode switch to
another position.
Full sales report
Department report
Individual group
total report on
department
Full group total
report on
department
PLU report by
designated range
PLU report by
associated
department
Transaction report
84
Mode switch position
OPX/Z X1/Z1 X2/Z2
X -- --
--
X1, Z1 X2, Z2
--
X1 X2
--
X1 X2
--
X1 X2
--
X2, Z2
X1, Z1
--
X1 X2
--
X1 X2
d
Dept. code : Department sales total
For dept. 1 to 20;
For dept. 21 to 40;
@
key: Amount of cash in drawer
A
key: Sales total
A
Reading:
d
Reading:
Reading: Group number
0
Reading:
Start
Reading:
PLU code
Resetting:
All PLUs
Start
@
PLU code
Reading: Associated dept. code
1 A
Reading:
Key operation
¡ π
Dept. key ( to
D
Dept. key (
P
Resetting:
@ d
@ d
All PLUs
End
@
PLU code
End
PLU code
D
)
¡ π
to )
A
p
P p
p