Troubleshooting - Flex S 47 M Bedienungsanleitung

Dust disposal bag
Put the disposal bag over.
Pull the opening of the disposal bag out
toward the back over the suction sup-
port.
Tightly seal the disposal bag with clo-
sure strips underneath the opening.
Dispose of the disposal bag according
to the local provisions.
Cleaning the electrodes
Release and remove the suction head.
Clean the electrodes.
Insert and lock the suction head.

Troubleshooting

Note
In case of a failure (e.g. filter breakage) the
appliance must be turned off immediately.
The failure must be remedied before the
appliance is put into operation again.
Suction turbine does not run
Check cables, plugs, fuse, socket and
electrodes.
Turn on the appliance.
20
English
Suction turbine turns off
Empty the container.
Suction turbine does not start again
after the container has been emp-
Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
Clean the electrodes as well as the
space between the electrodes.
Suction capacity decreases
Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
Replace the dust disposal bag paper fil-
ter bag (special attachment).
Ensure the filter cover properly locks
into place.
Replace the flat pleated filter.
Dust comes out while vacuuming
Check for proper installation of the flat
pleated filter.
Replace the flat pleated filter.
Automatic shut-off (wet vacuum
cleaning) does not react
Clean the electrodes as well as the
space between the electrodes.
Continuously check the filling level in
case of non-conductive liquid.
Automatic filter cleaning is not
working
Suction hose is not connected.
Automatic filter cleaning cannot be
switched off
Inform Customer Service
Automatic filter cleaning cannot be
switched on
Inform Customer Service
tied