Operating The Field Indicator; Quick Operation Guide - Endress+Hauser RID14 Anleitung

Operating the field indicator

6 Operating the field indicator
6.1

Quick operation guide

You have a number of options for configuring and commissioning the device:
1. Configuration programs
The configuration of FF functions and device-specific parameters is done via the fieldbus
interface. You can obtain special configuration and operating programs from various
manufacturers for these purposes (→ ä 49).
2. Miniature switches (DIP switches) for diverse hardware settings
You can make the following hardware settings for the FOUNDATION Fieldbus™ interface using
miniature switches (DIP switches) inside the field indicator housing:
• Switching the hardware write protection on/off
Fig. 9: Field indicator hardware configuration
6.1.1 Listener mode
The field indicator will analyze the active devices on the bus. Those will be listed and for up to 8
channels the according device can be chosen by its address. For this device the published values
will be reported and the value to be shown on the display can be chosen.
6.1.2 Function block connection mode
In function block connection mode, a published value that is subscribed by a function block
within the field indicator can be displayed. This can be IN and OUT parameters in the function
blocks.
44
RID14
a0011638
Endress+Hauser