Wear Parts - Oase AquaMax Eco Expert 21000 Gebrauchsanleitung

Replacing impeller unit
Note!
The impeller unit is guided in the motor block by a bearing. This bearing is a wear part and should be chan-
ged at the same time as the impeller unit.
 Changing the bearing requires specialist knowledge and tools. Have the bearing changed by your OASE
specialist dealer or send the pump to OASE.
Note!
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron filings).
 All particles must be removed from the impeller unit before reassembly. Any remaining particles can cause
irreparable damage to the impeller unit and motor block.
How to proceed:
 J
1. Remove the screws for fastening the filter basket and remove the filter basket.
2. Remove the screws for fastening the stand and remove the stand.
3. Remove the four screws and take off the pump casing.
4. Pull out the impeller unit and replace if necessary.
– Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
5. Reassemble the unit in the reverse order.

Wear parts

The following components are wear parts and are excluded from the warranty:
 Impeller unit
 Bearing in the motor block
Storage/Over-wintering
The unit is frost resistant to minus 20 °C. Should you store the unit outside of the pond, clean it thoroughly with a soft
brush and water, check it for damage, then store immersed in water or filled with water. Do not immerse the power plug
in water!
Repair
Repair is not possible in the following cases. The pump has to be replaced.
 If there is no replacement part approved by OASE for a defective component.
 If an electric cable permanently connected to the pump becomes damaged.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
- EN -
19