Entering Or Changing The Commission Number; Entering Or Changing The Joint Number - Hürner WeldControl 2.0 630 Bedienungsanleitung

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
The code has to be an ISO-compliant code. It can be entered either
using the cursor keys and confirming the input by pressing the START/
bar code with the optional handheld scanner.
an audible signal.

4.2.2 Entering or Changing the Commission Number

using the cursor keys or reading it with the scanner or from a RFID card
and then confirm the new number by pressing the START/SET key.
It is possible to select a previously saved commission number instead
of the one shown on the screen by pressing the
simultaneously. This causes the screen to show in which you can scroll
through the commission numbers in memory using the
to select a number and then confirm it by the START/SET key. This

4.2.3 Entering or Changing the Joint Number

was enabled in the Configuration Menu.
number. This means that it increments by 1 for every welding opera-
previously by entering the appropriate job number). In the example in
number 72 while the joint itself is joint number 2 of the current job/
commission.
The first joint of a commission for which no joint has been
highest number of the joints existing for that commission
Info
and uses this number plus 1. The user is shown the number
thus found on the screen and can apply or change it. If the
sure that no number is assigned twice in one commission. If
affect the welding process and the logging of its data in
the next welding operation will still be the highest existing
The joint number can also be entered after simultaneously pressing
the cursor keys and
Version January 2019
when Display 3 is showing on the screen.
HÜRNER WeldControl 2.0 630 User's Manual
and cursor keys
and
-
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 12
EN
15