EMAK efco BLE 506 Betribs- Und Wartungsanleitung Seite 219

► INSTALLATIE VAN DE GRASOPVANGBAK
► Screw the grass catcher hinges (1) on to the rear plate. For this purpose use the installation markings on the plate
indicating the correct position of the hitches.
3.3.2c
► Only screw on the lower hitch (2) if you will be using a trailer (optional equipment).
► Screw the front tube under the lid of the top frame.
3.3.2d
► Attach the contact spring for the full grass catcher sensor on the left side of the top frame plate.
3.3.2e
► Screw in the slanting tube into the grass catcher. For a grass catcher with a capacity of 320 l use the holes dichtbij
to the front tube; for the grass catcher with a capacity of 380 l use the holes verder weg from the front tube.
3.3.2f
► Tilt the grass catcher by 90
the front tube and the second side to the slanting tube. For the 320 l grass catcher use two braces, for the 380 l
3.3.2g
grass catcher use three braces.
► Pull the rubber edges of the sack over the front tube.
3.3.2h
► Screw the top handle to the lid and tighten the brace under the lid.
3.3.2i
► Insert the dump lever handle into the hole in the grass catcher lid.
► Into the holes in the bottom end of the lever, screw in a self-tapping bolt from the outside.
3.3.2j
► AANPASSING
VAN DE POSITIE VAN DE GRASOPVANGBAK NA INSTALLATIE
► Hold the grass catcher and hang it on the hitches on the rear plate of the machine.
► Check that the grass catcher and the mudguards match up. The arrow tips stamped on the lid of the grass catcher
and machine's fairing must point to each other while the distance between the grass catcher and the grass catcher
3.3.2k
plate should be no more than 3 mm.
► If the grass catcher is not in the correct position, loosen the bolts, holding the hitches (1) of the grass catcher to the
rear plate, set the grass catcher into the correct position and tighten the bolts.
► Also check the position of the contact spring of the full grass catcher sensor – the spring must be touching the
3.3.2l
switch (2), otherwise the mowing deck will not function.
o and from the bottom side screw on the lower braces. Attach one side of the braces to
219