Mitsubishi Electric PLFY-P20VFM-E1 Installationshandbuch Seite 14

5. Installing the grille
B
A
C
G
C
Fig. 5-7
E
Fig. 5-9
E
F
Fig. 5-11
D
A
E
D
Fig. 5-8
C
B
D
A
D
E
* Make sure that there are no gaps between the main unit and the grille or the grille
A Main unit
B Electric component box
C Screw with washer (Accessory)
D Grille
E Ceiling
F Make sure that there are no gaps.
G Temporary hanging hooks on the panel
Caution:
When tightening the screw with captive washer C
F
latched onto the hooks on the main unit.
1 Remove the one screw securing the connector box cover, slide the cover in the
direction indicated by the arrow as shown in the diagram, and then open the cover.
2 In the connector box, locate the junction wire for the vane motor of the grille and
the wire for the vane motor, and then connect the wires. (Fig. 5-9)
There are two vane motor connectors: one blue connector and one orange con-
nector. Make sure that the connector colors match when connecting them.
3 After placing the wires in the connector box, close the connector box cover. Make
When closing the connector box cover, slide the cover in the direction indicated by
A Connector box cover
B Connector box
C Securing screw
D Junction connector
E Wire connector for the vane motor
F Band
Caution:
shown in the diagram. (Fig. 5-11)
pinched.