Herunterladen Diese Seite drucken

Bio Green Frosty 4500 Installations- Und Bedienungsanleitung Seite 9

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Gewächshausheizung Frosty 2500 / Frosty 4500
10. Warranty and servicing
We offer a 3-year unlimited manufacturerʼs guarantee (effective from the date of purchase) on
2
all Bio Green products. Damage caused by external forces is excluded from this guarantee, as
are improper use and non-observance of cleaning and servicing as described in these
operating instructions.
Limitation of liability
Bio Green is not responsible for damage to plants or sooting of the heater caused by
inadequate air supply.
Important note
The apparatus may only be opened and repairs may only be carried out by authorised
specialists, in due consideration of the applicable instructions for repair. Only original
components may be fitted.
The guarantee for proper operation and operating safety can only be honoured if the apparatus
is properly installed and handled. This also applies in respect of statutory provisions governing
equipment safety as well as applicable accident prevention regulations.
Please advise your dealer of any damages during the term of the guarantee. Depending on the
fault, your apparatus will be exchanged, repaired or replaced. A CORGI-registered servicing
company is authorised to perform repairs after the guarantee period. Cleaning tasks are
charged for.
During periods of non-use in the summer, the apparatus should be stored in a closed container
(e.g. plastic bag) to protect it from spiders and insects, since these may block the gas
apertures, which must then be cleaned.
The cylinder valve must always be closed when the apparatus is stored. Protect the gas
cylinder from direct sunlight. Do not run the hose past hot areas.
11. Technical data
Gas type: liquid gas propane/butane
Category: I
- 50 mbar
3B/P
I
- 30 mbar
3B/P
I
- 37 mbar
3B/P
I
- 28-30/37 mbar
3+
Nozzle diameter:
Rated heat output (H
s
Gas consumption:
Technical and colour changes reserved.
Please refer to the nameplate on the side of the heater
for the category and operating pressure settings
of the apparatus.
2.5 kW
2,35 kW
4.5 kW
4,25 kW
):
2.5 kW / 2,35 kW
190 g/h / 180 g/h
Ø 0.64 mm at 50 mbar
Ø 0.73 mm at 30 mbar
2 x Ø 0.64 mm at 50 mbar
2 x Ø 0.73 mm at 30 mbar
4.5 kW / 4,25 kW
350 g/h / 320 g/h
9

Werbung

loading