Variations In Motor Control - Trix 66837 Bedienungsanleitung

Swapping the Connections (Velo)
If you have mixed up the connections when instal-
ling a decoder in an open wiring situation, you can
"correct" for this electronically. First check which
connections have to be changed, and then enter
the number from the following table as a value:
Motor Light
x x
– x
x –
– –
x x
– x
x –
– –
Important:
Changing the connections for the motor or the
track will result in corresponding changes in analog
operation.
Track Number
– 7
– 6
– 5
– 4 (standard)
x 3
x 2
x 1
x 0
AFB Effectiveness
With this you can set whether the programmed
acceleration / braking delay is only to be effective
in the (diode) braking area or always effective
(even when the hand controller is being used).
always in effect
only in stopping areas
Other numbers are not permissable.

Variations in Motor Control

With this value you can adapt the control for optimal
operation of the motor. There is no general rule on
which variations result in the best control behavior.
The only thing that can help is to make test runs
of the locomotive.
very hard
hard
soft
very soft
Caution:
Control variation 4 is recommended for can motors
with bell-shaped armatures, and in the standard
settings pulse width 1 is also recommended for these
motors. There is no coverage under the warranty for
damages to motors as a result of incorrect settings.
1
2
1
2
3
4
19