Dmx-Controlled Operation; Dmx-Protocol; Cleaning And Maintenance - EuroLite LED STL-9 Bedienungsanleitung

Dimmer curves (4 types):
Display:
LINEAR: the increase in light intensity appear to be linear as DMX value is increased.
SQUARE LAW: light intensity control is finer at low levels and coarser at high levels
INVERSE SQUARE LAW: light intensity control is coarser at low levels and finer at high levels
S-CURVE: light intensity control is fine at low levels and high levels and coarser at medium levels.

DMX-controlled operation

You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED STL-9 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED STL-9 correctly
and independently from any other fixture on the DMX-chain. If several LED STL-9 are addressed similarly,
they will work synchronically.
Controlling:
After having addressed the LED STL-9, you may now start operating it via your lighting controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.

DMX-protocol

DMX mode:
Display
Press the button Setup to set the DMX address from 001-512:
CH1
0-100%
Dimming

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
DIMMER
CURVE:01(-04)
Dimming Curves options:
DMX MODE
ADDR:001
CH2
0-100%
Flash speed
22/23 00063567.DOC, Version 1.2