Installation - Zanussi ZEE3921I Benutzerinformation

How to prevent a damage to the appliance
• Do not let acid liquids such as vinegar, lemon juice or
limescale removing agents to touch the hob. This will
cause matt patches
• Do not place wet pan lids on the hotplates and do not
let hot pans to cool on the hotplates. If not condensa-
tion and rust can form.
• Do not let cookware boil dry to prevent the damage to
cookware and hotplate.
• Do not use the solid hotplate with empty cookware or
without cookware.

Installation

Installation
Warning! Read and follow the instructions carefully.
There is a risk of injury or damage to the appliance.
• Make sure that the appliance is not damaged because
of transportation. Do not connect a damaged appliance.
If it is necessary, speak to the supplier.
• Installation and connection of the appliance to the
power supply must only be done by qualified person-
nel.
• Only use built-in appliances after you assemble the ap-
pliance into correct built-in units and work surfaces
that obey the standards.
• Do not change the specifications or modify this prod-
uct. There is a risk of injury or damage to the appli-
ance.
• Fully obey the laws, ordinances, directives and stand-
ards in force in the country where you use the appli-
ance (safety regulations, recycling regulations, electri-
cal safety rules etc.).
• Keep the minimum distances to other appliances and
units.
• Install anti-shock protection, for example install the
drawers only with a protective panel directly below the
appliance.
• If the fixing bracket is near to the terminal block, al-
ways make sure the connection cable does not come in
contact with the edge of the bracket.
• Prevent damage of the cut surfaces of the worktop
against moisture with a correct sealant!
• Seal the appliance to the worktop with no space left
with a correct sealant.
10
• Do not cover any part of the appliance with aluminium
foil.
Disposal of the appliance
• To prevent the risk of physical injury or damage
– Disconnect the appliance from the power supply.
– Cut off the mains cable where it connects with the
appliance and discard it.
– Speak to your local authorised facilities for disposal
of your appliance.
• Prevent damage of the bottom of the appliance from
steam and moisture, e.g. from a dishwasher or oven.
• Do not install the appliance adjacent to doors and be-
low windows. Hot cookware can be hit off the hob
when you open doors or windows.
• Disconnect the appliance from the electrical supply,
before you do maintenance work or cleaning.
Warning! Risk of injury from electrical current.
Carefully obey the instructions for electrical
connections.
• The electrical mains terminal is live.
• Make the electrical mains terminal free of voltage.
• Install correctly to give anti-shock protection.
• Loose and incorrect mains plug and socket connec-
tions can make the terminal become too hot.
• A qualified electrician must install the clamping con-
nections correctly.
• Use a strain relief clamp on cable.
• Use the correct mains connection cable and replace the
damaged mains cable with the proper cable type.
Speak to your local Service Centre.
The appliance must have the electrical installation which
lets you disconnect the appliance from the mains at all
poles with a contact opening width of minimum 3 mm.
You must have correct isolation devices: line protecting
cut-outs, fuses (screw type fuses removed from the hold-
er), ground leakage trips and contactors.
The manufacturer is not responsible for any injury to per-
sons and pets or damage to property caused by failure to
obey these requirements.
www.zanussi.com