Electrolux DUB5650HM Gebrauchsanleitung Seite 6

6 www.aeg.com
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button 1
Perform fi lter maintenance as
recommended in this manual.
In the event that both indicators of fi lter
saturation "F" and "C" start fl ashing,
proceed with the reset twice.
The saturation indicator of the charcoal
fi lter is not normally active and if the hood
is used in the recirculation mode, it must be
activated manually the fi rst time.
Activation of the charcoal fi lter
saturation indicator:
Turn off the hood and simultaneously press
buttons
The letters "F" and "C" will fl ash on the
display for 2 seconds, to indicate successful
activation of the saturation indicator of the
charcoal fi lter.
Deactivation of the charcoal fi lter
saturation indicator:
Turn off the hood and simultaneously press
the buttons
letter "F" will fl ash on the display for 2
seconds, to indicate successful deactivation
of the saturation indicator of the charcoal
fi lter.
Temperature Alarm
The hood is equipped with a temperature
sensor which activates the motor at speed
3 in case the temperature in the display
zone is too high.
The alarm condition is indicated by the
display with the letter "t" fl ashing.
This condition remains as such until the
temperature falls below the alarm threshold.
This mode can be quit by pressing key "2".
Every 30" the sensor checks the ambient
temperature of the display zone.
for about 3 seconds.
2 and 3 for 3 seconds.
2 and 3 for 3 seconds. Only
ood
5.1 Hob H
2
The hood is equipped with a function for
wireless connection with the cooktop for
automatic adjustment of the most suitable
speed. Refer to the instruction manual of
the cooktop to verify the presence and
compatibility of this function.
In the case of fi rst connection to the mains
or abrupt disconnection from power supply
(blackout), wait 1 minute to allow the hood
to restore the connection with the cooktop.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
To replace lights, contact authorised spare
part center.