Checking The Battery Charging Level; Operation; Changing Accessories; Speed Control - Parkside PABS 16 B3 Bedienungs- Und Sicherheitshinweise

Charging status LEDs
Green LED Charger ready
continuously lit
Red LED Battery pack charging
continuously lit
Green LED Battery pack fully charged
continuously lit
Red LED flashing Battery pack defect
Green LED flashing Battery pack too cold or warm
Checking the battery charging
Q
level
Press the on / off button
o
charging level of the battery pack
status / remaining charge will be shown on
the battery charging level indication lights
Green / red / maximum battery charging level
orange
Red / orange medium battery charging level
Red low battery charging level
Charge the battery pack
o
when it is at medium or low battery charging
level.

Operation

Q
CAUTION! RISK OF INJURY!
Keep your hands away from the tool when
u
the product is in operation.

Changing accessories

Q
CAUTION! RISK OF INJURY!
Accessories can be sharp and may
become hot during use. Always wear
protective gloves when handling
accessories!
This product is equipped with an automatic spindle
lock to open or close the spindle with the chuck
sleeve .
1
12 GB
to check the
7
. The
8
.
5
8 before operation
1. Push the rotation control switch
position to lock the on / off switch
2. Turn the chuck sleeve
spindle.
3. Insert a suitable accessory into the spindle as
deep as required.
4. Hold the accessory in position and turn the
chuck sleeve counter clockwise to close the
1
spindle.
5. Push the rotation control switch
position required for your application.
6. After short operation, switch the product off and
ensure the accessory is still properly fastened.

Speed control

Q
Speed selector
WARNING!
Do not actuate the speed selector unless the
u
spindle has come to a complete stop!
1. This product is equipped with a two speed
gearbox. The 1 gear is designed for screw
st
driving operations with low speed and high
torque, while the 2
operations with high speed and low torque.
2. Preselect the gear for your application by
moving the speed selector
1 gear: Speed selector switch
st
2 gear: Speed selector switch
nd
On / off switch
The on / off switch is combined with a speed
7
control. The speed increases or reduces depending
on how hard it is pressed. This allows you to change
the speed during operation.

Rotation control

Q
WARNING!
Do not actuate the rotation control switch unless
u
the spindle has come to a complete stop!
Change the direction of rotation by pushing the
o
rotation control switch
Push the rotation control switch
o
position to lock the on / off switch
(e. g. when changing accessories,
transportation).
to the centre
6
.
7
clockwise to open the
1
to the
6
gear is designed for drilling
nd
.
3
in position 1.
3
in position 2.
3
towards left or right.
6
to the centre
6
7