Hama SOUNDCUP-D Bedienungsanleitung Seite 6

• Make sure that your Bluetooth
capable terminal device is on and
Bluetooth is activated.
®
• Make sure that the speaker is located
within the Bluetooth
range of max.
®
10 metres.
• Switch on the speakers as described in
4.1 Switching the product on and off.
• The status LEDs (1) start ashing blue. The
two halves of the speaker then connect to
each other automatically.
• Once the halves have successfully connected,
the status LED (1) on one speaker lights
up blue.
• The status LED (1) on the master speaker
continues ashing blue while the speaker
searches for a connection to the terminal
device.
• Open the Bluetooth settings on your terminal
®
device and wait until Hama Soundcup-D
appears in the list of Bluetooth
found.
• Select Hama Soundcup-D and wait until
the speaker is listed as connected in the
Bluetooth
settings on your terminal device.
®
An acoustic signal con rms that connection
was successful.
• The status LED (1) on the master
speaker remains lit.
4
®
• Some terminal devices require a
password in order to connect to
another Bluetooth
• If your terminal device requests a
password for connection to the speaker,
enter 0000.
• If you want to connect a new
Bluetooth
speaker, press the function button
(1) twice in short succession until the
status LED
and an acoustic signal sounds.
• The current connection is disconnected
and the search for new terminal
devices
®
devices starts.
• The speaker always stores the last eight
terminal devices paired.
• The speaker will automatically connect
to the last terminal device paired when
it is switched on the next time.
Note – Bluetooth password
®
device.
®
Note – Connection to a new
device
terminal device to the
®
(1) begins to ash blue
4.4 Automatic Bluetooth
®
successful pairing)
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that the speaker is located within
the Bluetooth
range of max. 10 metres.
®
• Switch on the speakers as described in 4.1
Switching the product on and off.
• After successful connection, the status LED
(1) will light up in blue. An acoustic signal
con rms that connection was successful.
Note – Connection impaired
• After the speaker and terminal device
have been paired, a connection
is established automatically. If
the Bluetooth
connection is not
®
established automatically, check the
following:
• Check the Bluetooth settings of
®
your terminal device to see whether
Hama Soundcup-D is connected.
If not, repeat the steps listed under
Bluetooth
pairing.
®
connection (after
capable
®
is
®