EGO ST1510E Bedienungsanleitung Seite 18

TROUBLESHOOTING
EN
PROBLEM
Line trimmer fails to
start
Line trimmer stops
while cutting
18
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E
CAUSE
◾
The battery pack is not attached
to the line trimmer.
◾
No electrical contact between
the trimmer and battery.
◾
The battery pack is depleted.
◾
The lock-off button and
trigger are not depressed
simultaneously.
◾
The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
◾
Heavy cutting line is used.
◾
The motor shaft or trimmer head
is bound with grass.
◾
The motor is overloaded.
◾
The battery pack or line trimmer
is too hot.
◾
The battery pack is
disconnected from the tool.
◾
The battery pack is depleted.
SOLUTION
◾
Attach the battery pack to the line trimmer.
◾
Remove battery, check contacts and reinstall
the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off button and hold it, then
depress the trigger to turn on the line trimmer.
◾
Remove the battery pack and mount the guard
on the trimmer.
◾
Use recommended nylon cutting line with
diameter no greater than 2.4mm.
◾
Stop the trimmer, remove the battery, and
remove the grass from the motor shaft and
trimmer head.
◾
Remove the trimmer head from the grass.
The motor will recover to work as soon as
the load is removed. When cutting, move the
trimmer head in and out of the grass to be cut
and remove no more than 20cm of length in a
single cut.
◾
Allow the battery pack or trimmer to cool until
the temperature drops below 67°C.
◾
Re-install the battery pack.
◾
Charge the battery pack.