Replacing A Fuse - Sennheiser EM 3031-U Gebrauchsanleitung

17

Replacing a fuse

Disconnect the receiver completely from the mains! To do so, pull out the mains connector on
the receiver. You can then remove the fuse holder with the inserted fuse. Replace the fuse by a
new fuse with the same rating and switch on the receiver again. Make sure that you have inserted
the fuse holder in such a way that the receiver is operated with the correct mains power!
A faulty fuse should always be regarded as a warning. In most cases, the cause is harmless – a
short voltage surge or some similar cause has triggered the protective mechanism. When the fuse
has been replaced, the receiver works again.
If the replacement fuse also blows, please consult a specialist who can discover the cause. We
recommend you to contact your Sennheiser distributor or to send the receiver, with a precise
description of the trouble, to a Sennheiser service departement in your area. You can find the
address of your nearest service departement in the enclosed Service card or on the Internet under
"http://www.sennheiser.com".
45