Festina IFMOS2B Betriebsanleitung Seite 3

I
ENGLISH INSTRUCTION MANUAL
A) DISPLAYS AND BUTTONS
Chronograph second
Chronograph minute hand
Small second hand
B) SETTING THE TIME
1. Pull the crown out to the 2nd click position so that the second hand stops at zero position.
2. Turn the crown to set hour and minute hands.
3. When the crown is pushed back to the normal position, small second hand begins to run.
C) SETTING THE DATE
1. Pull the crown out to the 1st click position.
2. Turn the crown anticlockwise to set the date.
* If the date is set between the hours of around 9:00 PM and 1:00 AM, the date may not change on the following day
3. After the date has been set, push the crown back to the Normal position.
D) USING THE CHRONOGRAPH
This chronograph is able to measure and display time in 1/1 second united up to maximum of 59 minutes 59 seconds.
Measuring time with the chronograph
1. The chronograph can be started and stopped each time button "A" is pressed.
2. Pressing button "B" resets the chronograph and the chronograph second hand, chronograph minute hand, and
chronograph hour hand return to zero position
RESET
E) CHRONOGRAPH RESET( INCL. AFTER REPLACING BATTERY)
This procedure should be performed when the chronograph second hand does not return to zero position after the
chronograph has been reset, and including after the battery has been replaced.
1. Pull the crown out to the 2nd position.
2. Press button "A" to set the chronograph second hand to zero position. The chronograph hand can be advanced rapidly by
continuously pressing button "A".
3. Once the hand have been reset to zero position, push the crown back to the normal position.
* Do not push the crown to normal position while the chronograph second hand returns to zero position. It stops on the way
when the crown are returned to normal position and its position is recognized as zero position.
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making
products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other
authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and
protecting our health.
Hour hand
TIME MEASUREMENT
IFMOS2B
Minute hand
Button A
24 hour hand
Normal position
2nd click position
1st click position
Date
Button B
STOP