User Safety; Battery Safety - DeWalt DW099S Betriebsanleitung

Contents
GB
•

User Safety

•

Battery Safety

• Setup (Load Batteries)
• Operation
• Warranty
• Error Codes
• Specifications
Retain all sections of this manual for future
reference.
User Safety
WARNING:
Carefully read the Safety Instructions and
Product Manual before using this product.
The person responsible for the product must
ensure that all users understand and adhere to
these instructions.
WARNING:
The following label information is placed on
your laser tool to inform you of the laser class
for your convenience and safety.
DW099E
The DW099E and DW099S tools emit a visible laser
beam, as shown in Figure
emitted is Laser Class 2 per IEC 60825-1 and complies
with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No. 50, dated June 24, 2007.
WARNING:
While the laser tool is in operation, be careful
not to expose your eyes to the emitting laser
beam (red light source). Exposure to a laser
beam for an extended time period may be
hazardous to your eyes. Do not look into the
beam with optical aids.
WARNING: To reduce the risk of injury, user
must read the Product User manual, Laser
Safety manual, and Battery Safety information.
4
DW099S
FCC ID: 2ADA6DW099S
IC: 12409A-DW099S
#1. The laser beam
A
DeWalt, Slough, Bershire SL1 3YD, UK herewith
declares that the product DW099E/DW099S is in
compliance with the essential requirements and all
other provisions of Directive 1999/5/EC. Please contact
DeWalt for Declaration of Conformity.
Battery Safety
WARNING: Batteries can explode or leak and
cause serious injury or fire. To reduce the risk:
ALWAYS follow all instructions and warnings
on the battery label and package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries. Replace
all of them at the same time with new batteries
of the same brand and type.
DO NOT mix battery chemistries.
DO NOT dispose of batteries in fire.
ALWAYS keep batteries out of reach of
children.
ALWAYS remove batteries if the device will not
be used for several months.
NOTE: Ensure that the recommended
batteries are used.
NOTE: Ensure the batteries are inserted in the
correct manner, with the correct polarity.
Setup (Load Batteries)
1.
Locate the battery compartment latch on the back
of the tool (Figure
C
2. Using your finger, pull the latch up to unlock and
remove the battery door (Figure
3. Insert two AAA batteries, making sure to position
the - and + ends of each battery as noted inside the
battery compartment (Figure
4. Slide the pins at the bottom of the battery door into
the notches in the battery compartment
(Figure #4).
D
5. Push the battery door down until it snaps in place
(Figure #5).
D
When the tool is ON, the battery level appears in the
display window (Figure
E
#2).
#1 and #2).
D
#3).
D
#1).