Before Contacting Customer Service - Bompani BOMP104/B Anweisungen Für Installation, Gebrauch Und Wartung

Troubleshooting
2
u
If the appliance has no plug attached, it must
be connected to the electricity supply by installing
a switch which is directly connected to the mains.
This switch must ensure omnipolar disconnection
under overvoltage category III conditions.
TROUBLESHOOTING
1
) THE APPLIANCE DOES NOT WORK.
- Is there a power cut?
- Is the plug inserted properly in the mains socket?
- Is the power supply cable damaged?
- Is the temperature setting correct?.
2) THE TEMPERATURE INSIDE THE COMPARTMENTS IS NOT
LOW ENOUGH.
- Do the doors close properly?
- Is the appliance installed near to a heat source?
- Is the temperature setting correct?.
- Is the condenser clean?
3) THE TEMPERATURE INSIDE THE FRIDGE COMPARTMENT
.
IS TOO LOW
- Is the thermostat in the right position?
4) THE APPLIANCE IS VERY NOISY.
- Is the appliance in contact with other furniture or objects?
- Are the pipes on the back touching or vibrating?
- Is the appliance level?
5) THE INTERNAL LIGHT DOES NOT WORK
- First check point 1, then: REPLACING THE LIGHT.
- Disconnect the appliance from the mains.
969
3
2
C
MAX 15 W
1
4
- Remove the light cover C.
- Check the light and replace it with a new one if required (see
the voltage indicated in the figure ); remount the cover C
6) WATER IS FOUND ON THE FLOOR.
- Is tray V placed correctly and contacting the compressor
surface?
- Is discharge tube R placed correctly inside the tray?
TECHNICAL ASSISTANCE SERVICE
Before contacting the Assistance Service:
- Check whether it is possible to rectify the problem by refer-
ring to the "Troubleshooting" guide.
- Restart the appliance to check whether the problem has been
resolved. If the problem still exists, disconnect the appliance from
the mains electricity supply and repeat the operation after one hour.
If the appliance is not working properly or not working at all,
before calling the Technical Assistance Service check that:
- The plug is inserted properly in the mains socket.
- The mains supply is working.
- The temperature is set correctly.
- The doors close properly.
- The power supply voltage corresponds to that of the appli-
ance (± 6%).
- If the problem still exists, call the Assistance Service.
INFORM THE ASSISTANCE SERVICE OF:
- The type of malfunction
- The appliance model
- The serial number
EN
C
21