Team CMM 4 Gebrauchsanleitung Seite 9

Fax +32 2 359 95 50

Competent qualified electrician: customer service of the producer or importer or any person
(*)
who is qualified, approved and competent to perform this kind of repairs in order to avoid all
danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
WALL-MOUNTING BRACKET
To make the storage easier, your appliance is delivered with a wall-mounting bracket that you
can fix directly onto the wall thanks to the screws and raw plugs provided. Therefore measure
the space between the three notches on the backside of the mount and then make a hole in
the wall at the desired height and slide the raw plugs. Place the mount facing the holes, the
screws in the raw plugs and screw until there is the as least as possible play between the screw
heads and the mount.
MOUNTING THE MIXER STAND
Attach the mixer stand on the wall stand. The stand mixer fits together in the three notches
situated on the upper right part of the wall stand. To do so, put the upper notch first and then
pivot the stand to fit together to the remaining notches.
SPEED SETTINGS
Depending on the accessory you are using, we recommend you to use the following speed
setting.
STICK ATTACHMENT:
WHISK:
CHOPPER:
Variable speeds: place the speed switch on the speed setting you want and then press on the
switch.
USE OF THE STICK ATTACHMENT
With this accessory you can mix food as for example vegetables to prepare soups but also to
mix liquids. It only has to be used in a vertical position with blades facing downwards.
 Make sure the appliance is unplugged from the power supply.
 Insert the stick attachment in the opening so that the black arrow on the stick attachment
faces the white arrow on the appliance itself. Turn the stick attachment from a quarter of
revolution counterclockwise until both black arrows face each other. Check the locking
by pulling gently on the stick attachment.
 To disassemble the stick attachment, proceed inversely.
 Attention, the blades of the stick attachment are very sharp, pay attention not to get cut
when cleaning them.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
speeds MIN to MAX
speeds do not use speed MAX
speeds MIN to MAX
9
Assembly page 9/32
TEAM CMM 4 - 080425