Service; Fault Identification And Repair; Fig.10 Changing The Fluorescent Lamp - Igloo BALI Bedienungsanleitung

Fig.11 Changing the fluorescent lamp
1 – Upper panel plexiglas
2 – Plexiglas fixing handles
3 – Fluorescent lamp handle (upper panel lighting)
4 – Fluorescent lamp handle (upper lighting, internal)
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
During maintenance services it is necessary to pay attention not to damage the data place of the
device Fig.13 (p.20), which contains significant information for servicing organs and waste removal
companies.

6. SERVICE

6.1. Fault identification and repair

In case of any difficulties during actuation of the device or during its exploitation, please return to these chapters in this
manual, which explain the performed operation. This aims to ensure that the device is properly operated. If you still
experience difficulties, the following hints will help you solve the problem.
The device is not working... – Make sure that:
• The device is connected to the supply network
• Voltage and frequency in the network are compliant with those recommended by the producer, 230V/50Hz
• The main switch is turned on
• Thermostat is turned on (This concerns the Igloo thermostat – If only two spots are visible on the display – turn on
the thermostat)
The device is operating, but the lighting is off...– Make sure that:
• Lighting switch is turned on
• Fluorescent lamp or starting switch of the device are not burnt
Water leakage from under the device
• Check whether the device is properly levelled
• Empty the condensate container
The device does not reach the proper temperature, the lighting is on...– Make sure that:
• The main switch is on
• Temperature setting on the thermostat is properly set
• Thermostat works properly
• The condenser is clean, if necessary – clean the condenser
• Ambient temperature does not exceed 25ºC
18
User manual BALI
5 – Fluorescent lamp
6 – Casing of the fluorescent lamp and starting
switch
7 – Fluorescent lamp starting switch
8 – Casing of the fluorescent lamp
en
www.igloo.pl