Mode Selector - Yamaha M-5000 Bedienungsanleitung

¸
F.

MODE selector

Switches the speaker output between stereo and
monaural. For more information, refer to "Basic speaker
connections" (page 14), "Bi-wiring connections"
(page 18), "Bi-amp connections" (page 20), and
"Bridge connections" (page 22).
NORMAL: The unit is used as a stereo amplifier. This is
the standard setting.
DUAL MONO/BRIDGE: The unit is used as a monaural
amplifier. Select this setting for bi-amp or bridge
connections.
G. AUTO POWER STANDBY switch
ON: The unit enters standby mode automatically if it
is powered on but not operated for eight hours. This
function is disabled if the system cable is connected to
the TRIGGER IN jack.
OFF: The unit does not enter standby mode automatically.
B
¹
H.
TRIGGER IN jack
I. TRIGGER OUT jack
Used to connect a component that supports the trigger
function so that you can control the unit's power on and
off from that component. For more information, refer to
"Trigger connections" (page 13).
J. SERVICE jack
This jack is used to test the product.
K. AC IN jack
Connect the supplied power cord here. For more
information, refer to "Connecting the power cord"
(page 24).
L. Feet
If the unit is unstable, adjust the height of the feet as
needed by rotating them.
9