Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USING THE APPLIANCE
Before fi rst use
•
After transportation or storage in cold conditions it is necessary to let the device warm up at least 2 hours
at room temperature.
Battery charging
1.
Make sure that the switch 3 is in position "0".
2.
Insert the charging connector of the adapter 0 into the charging connector of the clipper 1.
3.
Insert the charging adapter 0 in the wall outlet and the indicator will light up 2.
4.
Charge the battery for 12 hours before fi rst use.
5.
After you fi nish charging the battery disconnect the charging adapter 0 from the outlet and disconnect
the connector of the power cable from the charging connector of the hair clipper 1.
Notes:
•
The next battery charging should last 6 to 8 hours.
•
Fully charged battery allows about 50 minutes of continuous operation.
•
If the movement of the blades will slow down and you need to continue using the clipper, you should let
the battery charge for at least 1 hour, or connect the AC adapter and use the clipper in power cord mode.
•
Charge the battery in temperature from +5 °C to +35 °C.
•
Never leave the device connected to the outlet unattended.
•
If you did not use the clipper for longer period of time (more than 2 months), perform before using it the
complete 12-hour battery charge.
Lubricating oil
To keep the clipper in continuous good condition you should lubricate the blades after each use (5 and 6).
Attention! Use only the lubricating oil qs included with the device. DO NOT USE vegetable oil, fat or mixture
of oil and solvents to lubricate the blades. The solvents evaporate and leave a thick layer of grease,
which can slow down the movement of the blades 5.
Using the hair clipper
Attaching and removing attachments
•
When attaching the attachment 7 or 8 insert the tab on one side of the attachment in the groove on the
body of the clipper 4 and push on the other side of the attachment so that the tab on the other side of
the attachment will fall in its place. The attachments are reversible, when you turn it you change the length
of the cut (3 / 6 mm or 9 / 12 mm).
•
When removing the attachment, push the projecting part of the attachment away from the body of the
clipper and remove the attachment.
Using the clipper
1.
Charge the battery fully for cordless use.
Note: When using with power cord, connect the adapter cable 0 to the clipper connector 1 and insert
the power adapter to the wall outlet.
2.
Before you start cutting hair, turn the clipper on by turning the switch 3 to position "1" and make sure that
the device is working properly and the blades move smoothly. If there is too much lubricate on the blades,
switch the clipper off and remove the excess grease using dry cloth from antipiling fabric.
3.
Turn the clipper off using switch 3.
4.
When attaching the adapter, observe the lengths of the hair marked on the attachments.
5.
Turn the clipper on by pushing the switch 3 to position "1" and start cutting.
6.
Turn the clipper off after use by pushing the switch to position "0".
Notes:
•
Always turn off the clipper when you pause cutting.
•
Turn the clipper off before changing an attachment and if you are using it with power cord, disconnect also
the power adapter 0 from the outlet.
GB
29
Werbung
Inhaltsverzeichnis
