HQ Power MICW42-2 Bedienungsanleitung Seite 3

4. Overview of the Receiver
a. Front Panel
1. headphones input jack
2. power switch
3. volume control
4. LCD
5. locking feature
6. ▲▼ buttons – selection buttons
7. SET – menu setting and confirmation button
b. Back Panel
1. power jack
2. input antenna A
3. balanced output
4. unbalanced output
5. audio attenuation level
6. input antenna B
5. Preparing the Receiver for Use
1. Connect the antennas to the BNC sockets at the rear of the receiver. Align them upwards in a V-shape.
2. Insert the DC power adapter in the power jack. Only use the included power adapter or an exact replacement.
3. Turn the volume completely to the left. Hold the power switch pressed for 2 seconds until the LCD lights.
4. Adjust the receiver‟s setup (see "7. Setup").
5. Turn off the unit by holding the power switch pressed for 2 seconds until the LCD turns off.
6. Overview of the LCD
1. RF indicator
2. AF indicator
3. mute
4. channel A signal reception
5. channel B signal reception
6. frequency display – current used frequency
7. channel display
7. Setup
a. Adjusting the Sensitivity
Hold the power switch pressed and switch on the receiver. Press SET until you see the display as below.
Wait 2 to 3 seconds. You will now be able to adjust the sensitivity.
Adjust the sensitivity using ▲ or ▼. The higher the value, the lower the sensitivity. It is recommended to set
the sensitivity to 20dB and not to go below 15dB. Press SET to confirm your choice.
MICW42 3 HQPOWER