ECOLAB EMP KKS E60 Bedienungsanleitung Seite 179

7.2.3.5 Installing the metering monitoring
NOTICE!
The metering monitoring function must be activated in menu first. The selection
must also be made of whether the pins 2+4 (input "pulse") or 3+4 (input
"metering lock") should be used for the metering monitoring input
Ä Chapter 10.3.13 'Configuration / Metering monitoring' on page 82).
(
Fig. 17: Installing the metering monitoring
2 + 4 = Input metering monitoring function with potential-free contact with selection
input „pulse" at configuration / metering monitoring (
10.3.13 'Configuration / Metering monitoring' on page 82).
PIN Assignment
2 Relay input
4 GND (┴)
1 +2 + 4 = Input metering monitoring function with electronic switch (NPN) with
selection input „pulse" at configuration / metering monitoring (
10.3.13 'Configuration / Metering monitoring' on page 82).
PIN Assignment
1 5 V, DC
2 Relay input
4 GND (┴)
or
3 + 4 = Input metering monitoring function with potential-free contact with selection
input „metering lock" at configuration / metering monitoring (
10.3.13 'Configuration / Metering monitoring' on page 82).
PIN Assignment
3 Relay input
4 GND (┴)
1 +3 + 4 =Input metering monitoring function with electronic switch (NPN) with
selection input „metering lock" at configuration / metering monitoring (
10.3.13 'Configuration / Metering monitoring' on page 82).
PIN Assignment
1 5 V, DC
3 Relay input
4 GND (┴)
Ä Chapter
43
Device installation
Ä Chapter
Ä Chapter
Ä Chapter
417101442 Rev. 12-02.2019