8
Teaching the switching output
It is possible to set two threshold values inside the analog value of 4 – 20 mA.
Depending upon the values programmed into the switching output, and the status of the actual
measured value, the switching output will either be High or Low.
For teaching the threshold value, it is necessary to simulate the tolerance position of the object or
the tolerance size of the object.
One switching output procedure:
SET
min. 2 sec
TEACH
< 5 sec
"TEACH" LED is blinking slowly
place an object, which repre-
sents the first tolerance value
SET
TEACH
"TEACH" LED blinks fast for a
short time
place an object, which represents
the second tolerance value
Seite / Page 65
SET
TEACH
"TEACH" LED blinks fast for a
short time
the two thresholds are taught