Brill 36 EH Gebrauchsanweisung Seite 24

to be removed nor bypassed as
this can result in injury.
Make sure that there are no
GB
other people (especially children)
or animals within or near the
working area.
Powered equipment can cause
serious injuries! You are
responsible for safety in the area
where you are working.
Never start the equipment whilst
tilted – risk of injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Make sure that the air vents are
free of dirt.
Ensure that you are standing
safely and on firm ground, even
on a slope.
If the power cable should get
caught in the cutting tool, switch
the appliance off and remove
the plug.
Be careful if you change direc-
tion on a slope, turn the machine
round or draw it towards you.
Be careful if you are going back-
wards, risk of stumbling!
Work at an angle to the slope,
never upwards and downwards.
Do not work on excessively
steep slopes.
Only push the equipment at
walking pace.
Only use the appliance at
a walking pace. Take special
care when turning the appliance
around or pulling it closer to
you.
24
Turn the motor off if the equip-
ment has to be tilted when trans-
porting it over surfaces other
than grass and if you are trans-
porting the equipment backwards
and forwards to the work area.
Never use the appliance if the
protective devices are not
mounted or if they are damaged.
When starting or operating the
starter switch take care as stipu-
lated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the
cutting tool.
When starting or switching on the
motor, the machine should not
be tilted unless the machine has
to be raised during the process.
In this case only tilt it as far as
absolutely necessary and only
raise the side away from you.
Do not start the motor when
you are standing in front of the
discharge duct.
Keep your fingers and feet away
from the cutting tool!
Keep your hands and feet away
from the interior housing and
discharge when the motor is run-
ning.
Never lift or carry a machine
with the motor running.
Stop the cutting tool if it should
be necessary to tilt the appliance
or if it is transported across
surfaces other than grass, and
when moving the appliance
from and to the surfaces which
are to be worked on.
Each time you have to work on
the machine or leave it or top it
up, always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Unplug from the mains.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to
vibrate strongly, unplug from the
mains and ascertain the cause.
Should the power cable be dam-
aged during use, the plug must
be immediately pulled out of the
socket. Under no circumstances
should the power cable be
touched before the plug has
been pulled out.
A
Taking a Break
Never leave the equipment
unattended. If you stop work,
unplug the equipment from
the mains and store the equip-
ment in a safe place.
If you stop work to go to a dif-
ferent work area, it is essential
to turn the equipment off and
unplug from the mains.
Beware of Environmental
A
Influences
Never use the equipment in the
rain or in damp, wet conditions.
Never work immediately adjacent
to a swimming pool or garden
pond with electrical equipment.
Comply with local quiet periods
in your community!
A
Electrical safety
Check the power cable regularly
for damage and signs of wear.
Only use permitted extension
cables.
Unplug the mains plug immedi-
ately if the mains cable/extension
cable is damaged or severed.
As a user of the appliance, you
are responsible for Third parties
in your range of action.