Periods Of Non-Operation; Troubleshooting - ZANKER KBA14411SB Benutzerinformation

Defrost the freezer when the frost layer reaches a
thickness of about 3-5 mm.
1. Switch off the appliance, or pull out electrical plug
from the wall socket.
2. Remove any stored food, wrap it in several layers
of newspaper and put it in a cool place.
Warning! Do not touch frozen
goods with wet hands. Hands can
freeze to the goods.
3. Leave the door open.
In order to speed up the defrosting process, place a
pot of warm water in the freezer compartment. In
addition, remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry the interior
thoroughly.
5. Switch on the appliance.
After three hours reload the previously removed food
into the freezer compartment.

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The lamp does not work.
The compressor operates continual-
ly.

Periods of non-operation

When the appliance is not in use for long periods, take
the following precautions:
1. Disconnect the appliance from electricity supply.
2. Remove all food.
3. Defrost the appliance (if necessary).
4. Clean the appliance and all accessories.
5. Leave the door/doors open to prevent unpleasant
smells.
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products to be frozen
were put in at the same time.
The room temperature is too high.
Caution! If you want to keep the
appliance switched on, ask somebody to
check it once in a while to prevent the
food inside from spoiling in case of a
power failure.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact a
qualified electrician.
Check if the appliance stands sta-
ble.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait a few hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
21