Installation - Siko MA02/1 Benutzerinformation

User Information
MA02/1
Electronic Display
ENGLISH
1. Warranty information
• In order to carry out installation correctly, we
strongly recommend this document is read very
carefully. This will ensure your own safety and
the operating reliability of the device.
• Your device has been quality controlled, te-
sted and is ready for use. Please respect all
warnings and information which are marked
either directly on the device or specified in this
document.
• Warranty can only be claimed for components
supplied by SIKO GmbH. If the system is used
together with other products, there is no warranty
for the complete system.
• Repairs should be carried out only at our
works. If any information is missing or unclear,
please contact the SIKO sales staff.
2. Identification
Please check particular type of unit and type
number from the identification plate. Type num-
ber and the corresponding versionare indicated
in the delivery documentation.
e.g. MA02/1-0023
MA02/1 Datum 31.01.02
version number
type of unit
Art.Nr. 78246

3. Installation

For mounting, the degree of protection specified
must be observed. If necessary,protect the unit
against environmental influences such as
sprayed water, dust, knocks, extreme tempera-
tures.
Built-in housing EG
• Push the device into the panel (1) until the
panel clips (2) hold the housing loosely.
Press the lateral centering (3) slightly down and
push the housing into the cut-out (1) until the
panel clips (2) snap completely.
3
Fig. 1: Installation
Bench housing TG
The rubber feet can be removed in order to screw
down the unit.
Attention !Maximum screw insert depth of 6.5
mm must be strictly adhered to!
4. Electrical connection
• Only fix / remove connectors with power off!
• Wiring must only be carried out with power off!
• Provide standed wires with ferrules.
• Check all lines and connections before swit-
ching on the equipment.
Interference and distortion
All connections are protected against the effects
of interference. The location should be selec-
ted to ensure that no capacitive or inductive
interferences can affect the display or the
connection lines! Suitable wiring layout and
choice of cable can minimise the effects of
interference (eg. interference caused by SMPS,
motors, cyclic controls and contactors).
Z.Nr. 8664064
1
2
Änd.Stand 034/02 9