Troubleshooting - Worx WG779E Bedienungsanleitung

TROUBLESHOOTING

Problem
1. Mower doesn't run when
switch lever is activated.
2. Motor stops while mowing.
3. Mower runs but cutting
performance is unsatisfactory,
or does not cut entire lawn.
4. Mower is too hard to push.
5. Mower is abnormally noisy
and vibrates.
20
6. Battery charger LED's not on.
7 . Battery charger LED does not
flip to green.
8. Mower not picking up
clippings with the Grass
Collection Bag.
9. When mulching there are
clippings visible.
10. Low or diminished run-time
after many uses.
11. The battery charger LED
flashes red and the battery
can't be charged.
Cordless Lawn Mower
Solution
A. Check to make sure safety key has been installed and is fully seated and
that button on switch housing is being completely pushed.
B. Release Switch Lever to turn mower off. Remove safety key, turn mower
over and check that blade is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
A. Release Switch Lever to turn mower off. Remove safety key, turn mower
over and check that blade is free to turn. If not free, return to an authorized
servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing
mower slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait for green light to
come on.
B. Release Switch Lever to turn mower off. Remove safety key. Turn mower
over and check: Blade for sharpness - Keep blade sharp. Deck and discharge
chute for clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise
cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each wheel for
free rotation.
A. Release Switch Lever to turn mower off. Remove safety key. Turn mower
on side and check blade to ensure it has not been bent or damaged. If blade
is damaged, replace with a replacement blade. If the underside of the deck is
damaged return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates:
Release Switch Lever to turn mower off, remove safety key and remove
blade. Rotate blade 180 degrees and retighten. If mower still vibrates, return
the mower to an authorized service center.
A. Check plug connection.
B. Replace charger.
A. Battery needs to be diagnosed. Take to authorized service center.
A. Remove mulch plate when bagging.
B. Chute clogged. Release Switch Lever to turn mower off. Remove safety
key. Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of the
cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten length of the
cut. Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
A. Return to Authorized Service location - may need new battery.
A. The battery overheats after continuous use. Remove battery from the
charger and allow it to cool to 42 C or less.
0
EN