Positioning The Product; Resetting To The Factory Settings; A) With The "Reset" Button On The Device - Conrad N150 Bedienungsanleitung

13. Positioning the Product

• The product is intended for the outdoor area. Of course, the device may also be used indoors.
• The product offers protection type IPX4. This means that it is protected against water splash
on all sides. Therefore, it should be installed in the outdoor area so that it is not exposed to
any direct weather infl uence.
• Otherwise, the device may be used anywhere. Observe that the WLAN range will still be
limited, e.g. for operating mode "Wireless ISP", depending on environment. This is the same
for the other two modes. The site of setup is limited to the max. permissible cable length of
approx. 100 m for 10/100 MBit networks. This also applies for networks with PoE.
• Please remember to close the lid of the device again after connecting all cables.
• There are different ways of attaching the router. One is using the enclosed cable tie to install it
to a wall holder or a pipe. The other is the wall attachment. You need two screws for this (not
enclosed) that must be screwed into the wall fi rst. Then the device can be attached there.

14. Resetting to the factory settings

a) With the "Reset" Button on the Device

• Connect the PoE adapter to the plug-in mains adapter and plug it into a mains socket to reset
the router to the factory settings without web interface. Connect the PoE adapter to the router
and wait for approx. 1 minute until the starting process is completed.
• Then push the recessed button "Reset" at the device
(black circle in the fi gure) with a thin, pointed object for
about 5 to 10 seconds and release it again. Whether or
not the reset was accepted can be seen by all LEDs ex-
cept for the Power LED at the router going out for a cer-
tain time after a few seconds.
• The device now restarts. This will table take about 1 minutes. Then it is reset to factory set-
tings.
71