3M PX5 Bedienungsanleitung Seite 12

Operating
5
Switch on the projector power
Press the STANDBY button on the remote control
or the projector.
STATUS STANDBY
The first time the power is switched on after pur-
chase, [Menu Language Select] will be displayed.
See Page E-13
• The STANDBY indicator starts flashing green, then
stops flashing, remaining lit, after about 60 sec-
onds. If the STATUS indicator lights up green at
the same time, the lamp mode is set to the Eco-
mode.
If the "Password" input window is displayed:
The correct password must be input or the projector
cannot be used. For instructions on inputting the
password, refer to the operating instructions (on the
CD-ROM). For instructions on turning off the power,
see page E-14.
The projector is now capable of regular projec-
tion.
Note:
• The image can be muted quickly by closing the
lens cover while the image is being projected.
6
Switch on the power of the connected equipment
7
Select the input
Main unit operation: Press the SOURCE button.
Remote control operation: Press the desired button from among the input selection buttons.
Precautions
G When the power plug will be unplugged from the power outlet, please place the projector near the
power outlet so that it may be reached easily.
G Press the STANDBY button after the STANDBY indicator is lit in amber.
(button on main unit)
STATUS STANDBY
Lit amber
E-12
STATUS STANDBY STATUS
Flashing green
Lit green
(Approximately
Power is on
60 seconds)
STANDBY