I Outdoor Unit; Screen Configuration; Setting The Day Of The Week And Time - Mitsubishi Electric SEZ-KD25VAQ Bedienungshandbuch

2. Parts Names

I Outdoor unit

3. Screen Configuration

Function Selection of remote controller
A
Standard Control Screens
OFF
B
Timer Monitor
MON
TIMER
OFF
˚F˚C
WEEKLY

4. Setting the Day of the Week and Time

TIME SUN
˚C
TEMP.
2 MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
A
Note:
G The day and time will not appear if clock use has been disabled at Function
Selection of remote controller.
G After the power supply returns, the indoor unit does not operate for three
minutes. Above operation is normal.
4
Set Day/Time
TIME SUN
D C
˚F˚C
˚C
ON
C
Timer Setup
SUN MON TUE WED THU FRI SAT
B
1
Day of the Week &
Time display
˚C
9
ON/OFF
4
FILTER
CHECK TEST
OPERATION
CLEAR
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
G Function Selection of remote controller:
G Set Day/Time:
G Standard Control Screens:
G Timer Monitor:
G Timer Setup:
<How to change the screen>
A :Hold down both the Mode button and the Timer On/Off button for 2
seconds.
WEEKLY
B :Press the Timer Menu button.
C :Press the Mode (Return) button.
D :Press either of the Set Time buttons (
2
1. Press the or
2. Press the Timer On/Off (Set Day) button 9 to set the day.
* Each press advances the day shown at 3 : Sun → Mon → ... → Fri →
Sat.
3. Press the appropriate Set Time button A as necessary to set the time.
* As you hold the button down, the time (at 4) will increment first in
minute intervals, then in ten-minute intervals, and then in one-hour in-
tervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button 4 to lock in the values.
Note:
G Your new entries at Steps 2 and 3 will be cancelled if you press the Mode
(Return) button 2 2 2 2 2 before pressing the Filter
5. Press the Mode (Return) button 2 to complete the setting procedure.
This will return the display to the standard control screen, where 1 will
now show the newly set day and time.
Set the functions and ranges available to the re-
mote controller (timer functions, operating restric-
tions, etc.)
Set the current day of the week or time.
View and set the air conditioning system's oper-
ating status
View the currently set timer (weekly timer, sim-
ple timer, or Auto Off timer)
Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
or ).
3
Day of the Week Setting
TIME SUN
4
Time Setting
Set Time button A to show display 2.
button 4 4 4 4 4 .