Mounting; Electrical Connection; Maintenance, Repair And Disposal; Approvals/Standards - IFM Electronic ecomat100 CR0301 Montage- Und Installationshinweise

C C CR0301
ABINET ONTROLLER

3. Mounting

The controller is to be mounted in a dry and enclosed environment (e.g. control
panel of the driver's cab, separate control boxes etc.).
It is mounted with 4 screws M4 x L.

4. Electrical connection

To protect the whole system (wiring and controller) the individual electric circuits
must be protected.
Designation
supply voltage
supply voltage digital outputs
supply voltage relay outputs
(relay 0...2)
supply voltage relay outputs
(relay 3...9)

5. Maintenance, repair and disposal

As the Controller does not contain any components which must be maintained
by the user, the housing must not be opened. The maintenance of the controller
may only be carried out by the manufacturer. The disposal must be carried out
according to the corresponding national environmental regulations.

6. Approvals/standards

Test standards and provisions ➔ Technical data.
The CE Declaration of Conformity and the E1 approval are available at:
www.ifm.com
12
PAGE
➔ Data sheet direct ➔ CR0301 ➔ Approvals
Potential Connector : Pin no.
U X1:01
B
U X3:05/10
COM01/02
U X5.1:02/06/10
COM03...05
U X5.1:14/16
COM06...12
X5.2:02/06/10/14/16
Fuse
max. 2 A
max. 16 A
max. 10 A
max. 2 A