Herunterladen Inhalt Inhalt Diese Seite drucken

Mount The Plasma Display In The Ceiling Unit - Panasonic TY-CE42PS20 Installationsanleitung

Deckenhalterung
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 10
Fitting procedure
5. Preparing the plasma display
Attaching the insulation spacers
 Place the front surface of the plasma display on a clean
cloth that has no dirt or foreign objects on it, and follow the
procedure below.
If the plasma display has any protruding parts, take care not
to scratch or damage them.
 Remove the four caps from the plasma display using a
Phillips head screwdriver.
Note
• Keep the caps that were removed in a safe place.
(They will be required if you use the pedestal.)
 Using the supplied Allen wrench  , mount the supplied 4
Allen head countersunk screws  , 4 dished toothed washers
 and 4 insulation spacers  at the locations where the
caps were removed as shown in the figure on the right.
(Tightening torque: 3 to 4 N•m)

6. Mount the plasma display in the ceiling unit

 Engage the upper insulation spacers of the plasma
display with the cutouts of the ceiling-hanging
bracket, and slowly lower the display into place.
 While lifting the plasma display slightly, insert the
lower insulation spacers into the holes at the lower
part of the ceiling-hanging bracket.
CAUTION
• If the plasma display is lifted too much, its top part will
become disengaged from the ceiling-hanging bracket.
16
Blanket
Blanket
Insulation spacer
Phillips head screwdriver
Cap
Cutout
Cutout

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis