Connecting To Measuring Device - Gossen MetraWatt METRAFLEX 3000 Bedienungsanleitung

_______________________________________________________________
4.3

CONNECTING TO MEASURING DEVICE

Read safety section of instructions before operating
this product.
METRAFLEX 3000: Plug the output cable of the current sensor
into the voltage measuring input terminals of the multimeter
(black to GND, red to V) and switch it to V AC.
METRAFLEX 3001/3003: Plug each output cable of the current
sensor to the current measuring input terminals "I" on the
MAVOWATT|50.
METRAFLEX 3003 also the phase labeling L1, L2, L3.
METRAFLEX 3001XL/3003XL: Plug each output cable of the
current sensor to the current measuring input terminals on the
MAVOWATT 20/30/40/70 or MAVOSYS 10. With METRAFLEX
3003XL observe the phase labeling.
_______________________________________________________________
Observe the polarity (color) and with