Technical Data; Installation; Operation - EL BJORN TF 15HV Bedienungsanleitung

TECHNICAL DATA

Machine dimensions
H incl. air distributor
H excl. Air distributor
W
D
Weight
Noise level
Motor and air side
Rated voltage
Power output
Rated current
Fan wheel max rpm
Air flow
Water side
Connection
Max. inlet water pressure
Max. inlet Water pressure 1.0 MPa
Water flow
Protection rating
Power output 17 kW at following values:
-
-
-
Certifications
EU Declaration of Conformity see www.elbjorn.com

INSTALLATION

INSTALLATION
Position the TF 15HV in the most central place possible.
Release the air distributor. Place the machine so that the air
intake is not obstructed
against a wall. Alternatively, attach the machine to a wall using the
keyhole mountings.
Consult the responsible water, heat and sanitation contractor.
Connect the electrical cable to a power distribution box with a
residual current trip. Start the machine with the switch.
PRE-OPERATION INSPECTION
• Check that the machine is connected to an electrical outlet
with a residual current trip.
• Check that no water is leaking from the connectors.
• Check that the machine is in a stable position and cannot roll
away.

OPERATION

HANDLING DURING NORMAL OPERATION
Turn the control switch one step to the right to start at lowest
fan speed. The next step is intermediate speed and the third step
provides max. fan speed. The control switch must be turned back
745mm
620 mm
556 mm
360 mm
31 kg
max. 65 dB (A)
230 V~-50 Hz/50Hz
160 W
0.55 A
1370
60/830/1040 m3/h
25 mm
Water temp. 85°
0,13 l/s
IP 44
Water temp. 80° / 50°
Water flow 0.13 l/s
Inlet Air temp. +5°
CE,S
to position 0 to stop the fan.
The machine can be operated with the fan at either of the lower
speeds to achieve a higher temperature output when starting in
sensitive environments.
HANDLING DURING ABNORMAL OPERATION
In the event of malfunction or leakage, turn the machine off and
disconnect the electrical cable. Turn off the valves and contact a
qualified professional.
DEINSTALLATION
When dismantling the machine: Turn off the incoming water
supply. Switch off the power to the machine and disconnect the
electrical cable. Start by emptying the water from the supply hose's
venting nipples. Once the pressure has dropped, loosen the hoses
from the incoming water.
Now disconnect the hoses one at a time, bearing in mind that the
hoses still contain water.
Disconnect the hoses from the machine and lift the rear of the
machine onto a board to empty out all the water. Pour approx
2 litres of antifreeze into the machine. Be aware of the risk for
freezing. Be very careful when draining out the water.
The machine can now be transported.
NOTE! Be aware of the risk for freezing. Be very careful
when draining out the water.
15
EN